Booted from partition 1 DRAM: Validate Shmoo parameters stored in flash ..... OK
ICX7150-12 (POE), PVT1 SYS CPLD VER: 0x4 Released Ver: 0xa Writing Shmoo values into flash .....
device 0 offset 0xbfe00, size 0x200 device 0 offset 0x0, size 0xc0000 Enter 'b' to stop at boot monitor: 0 device 0 offset 0x0, size 0xc0000 bootdelay: === Booting image from Primary
NAND read: device 0 offset 0x0, size 0x2000000 5 ecc_errors after reading 1b38000:1b39c00 iproc_nand_read_page returned 2 NAND read from offset 0 failed -22 0 bytes read: ERROR ## Loading kernel from FIT Image at 70000200 ... Bad FIT kernel image format! ERROR: can't get kernel image! could not boot from primary, no valid image; trying to boot from secondary device 0 offset 0x0, size 0xc0000 BOOTING image from Secondary
NAND read: device 0 offset 0x4000000, size 0x2000000 7 ecc_errors after reading 5b38000:5b39c00 iproc_nand_read_page returned 2 NAND read from offset 4000000 failed -22 0 bytes read: ERROR ## Loading kernel from FIT Image at 70000200 ... Bad FIT kernel image format! ERROR: can't get kernel image! ICX7150-Boot>
Recovery would look something like below. You will need to customize it for your scenario:
setenv ipaddr - set ip address setenv netmask <255.255.255.0> - set subnet mask setenv serverip - set tftp server address setenv gatewayip - set gateway address printenv - Try to ping your TFTP server. If you cannot ping, check your connections. Once ping is successful, enter these commands: setenv uboot spz10106.bin (change boot code image as needed) setenv image_name sps08080e.bin (change OS image as needed) saveenv tftpboot
If you are having issues with this, I would recommend opening a support case and one of our engineers can assist you.
Ben Beck, RCNA, RCNI, Principal Technical Support Engineer support.ruckuswireless.com/contact-us