cancel
Showing results for 
Search instead for 
Did you mean: 

H500 keeps updating configuration

yassine_ben_sli
New Contributor III
I have a SCG SmartZone 104 with OS version 3.4.2.0.152 ( the recommended one).
I have a Cisco network. I have configured the DHCP server with option 43 related to Ruckus.
Now I plug in R500s and it gets an IP adress and loads the OS and the configuration and works fine.
When I plug in the H500s it gets an IP adress, gets detected by the SZ but keeps in the updating configuration phase. As you can see in the attached picture, it keeps updating the configuration until it is disconnected.

Thank you for your attention,Image_ images_messages_5f91c3e2135b77e2478c836b_65f5f38d91494fe1971a4e6377d67366_RackMultipart20170717479371v3d-54e83d13-003a-4d22-bb87-6179034aadee-664163158.png1500286940 
7 REPLIES 7

hyosang_choi
Valued Contributor
Hi yassine.

If it works bad onto only H500, it may bug.

In workaround, make some ap-group having only 5Ghz SSID and the H500s move to the ap-group.

Try it.

I have exprienced similary symptom on 3.1.x version.

Regards. 

raazuko
New Contributor III
Disabling ap-cert-check in vSZ worked for me on this issue.

yassine_ben_sli
New Contributor III
Hi,

The solutions is to change the Country code to the one that it came with and disable ap-cert-check.

Regards