Ruckus ICX 7150-48

[Judomuerte]

I've recently purchased a ICX 7150-48ZP and I'm unable to log into the webgui with username and password (can ssh fine).  Online queries seem to indicate that I would need a layer 3 license.  Am I screwed?  I would love full functionality as I currently own a very expensive standard switch. SPR08095sufi is the latest firmware I've installed.  Any help, or a point in the right direction would be very much appreciated.

[Yarenis]

Hi @Judomuerte,

The user for SSH and Web must be the same, unless it has been changed. Let me provide a few commands that will enable Web access and ensure the same credentials used for local SSH access are enabled for WEB access.

1. Check if Web access is enabled:

    

   show web

   2. Verify that the local credentials are the ones used to authenticate Web access:

       

      show run | include aaa

      You should see the following result:

       

      aaa authentication web-server default local

      3. If you don’t see this output, configure it so that the credentials used for Web access are the local ones:

          

         configure terminal

         aaa authentication web-server default local

         write memory

         Support documentation

         Configuring Web Access

         https://docs.commscope.com/bundle/fastiron-10020-managementguide/page/GUID-F4B3233B-B04D-4BF7-A0CE-A...

         aaa authentication web-server

         https://docs.commscope.com/bundle/fastiron-08095-commandref/page/GUID-E60DB55B-5E68-40EC-A999-73C6C0...

         Best regards, 

         Yarenis Hernández. 

         Technical Support Engineer | L2 TAC Wired 

         COMMSCOPE 

         now meets next 

         10:00 AM to 7:00 PM MDT |  Sun& Mon- Off 

         Have a question or need to escalate“Chat Now” 

         RICXI|RCNA|CCNA|