cannot authenticate or get DHCP address

[sparkis_greenbr]

New to Ruckus. Want to simply thorw a static IP on ruckus ap. Have Ruckus AP give out DHCP to clients on single wireless network. Route traffic through Ethernet 2 to firewall. 

Internet - assigned static ip w/ gateway IP as firewall
Local Subnet 1 - assigned static ip (same subnet as Internet) and enabled DHCP server Access VLAN 1
Radio 2G - configured Wireless. Packet Forward - Bridge to WAN
Ethernet Port2 - Enabled Access Port, Bridge to WAN Vlan1

Can someone please point me in the right direction as to what I am doing wrong. I cannot get the Wireless to provide a DHCP address - 

I can also give out DHCP addresses from Firewall. If I do that do I only need to configure Radio and Ethernet Port 2?

Thank you in advance

SJMP

[monnat_systems]

Pls do run the command which you executed earlier

[sparkis_greenbr]

i did that - followed by a RESTART

[monnat_systems]

Just for these andorid n Linux disconnection can u pls use static channel for sometime...on both 2.4 n 5ghZ

U will find this wireless 2.4 and 5ghz

[monnat_systems]

Ok

[sparkis_greenbr]

Set both frequencies to static channel. Same thing - 

You see both clients registering on the AP under Status -> Radio 2.4G -> Connected Devices - but both have blank entries under IP address