cancel
Showing results for 
Search instead for 
Did you mean: 

cannot authenticate or get DHCP address

sparkis_greenbr
New Contributor III
New to Ruckus. Want to simply thorw a static IP on ruckus ap. Have Ruckus AP give out DHCP to clients on single wireless network. Route traffic through Ethernet 2 to firewall. 

Internet - assigned static ip w/ gateway IP as firewall
Local Subnet 1 - assigned static ip (same subnet as Internet) and enabled DHCP server Access VLAN 1
Radio 2G - configured Wireless. Packet Forward - Bridge to WAN
Ethernet Port2 - Enabled Access Port, Bridge to WAN Vlan1

Can someone please point me in the right direction as to what I am doing wrong. I cannot get the Wireless to provide a DHCP address - 

I can also give out DHCP addresses from Firewall. If I do that do I only need to configure Radio and Ethernet Port 2?

Thank you in advance

SJMP
47 REPLIES 47

monnat_systems
Valued Contributor II
if your gw/fw is configured to give away DHCP IP and if you create packet forward - bridge to WAN. this should do the trick...

sparkis_greenbr
New Contributor III
Still does not give out an IP address. Goes to Authenticating, then for a second "obtaining ip address" then back to Authenticating. Definitely using correct Password. 

also see SSID island-02FFB0 pop up - assume there is an error somewhere?

also for testing...just give a static ip on the testing device. this static IP shall be from local subnet pool...give it a shot...