Greetings!
Recently acquired a ZF7982, factory reset it, and am using it as a standalone ap.
It is currently running the most recent FW: 9.6.1.0.15
If I set up a 2.4 or 5 ghz network, give it a name, change some settings, then enable wpa2, psk, aes and give it a password and hit update, it reloads the page and then blanks out all of the information, like the attached screenshot.
After that I cannot update or edit any of the settings and the only way to make it work is to factory reset the ap.
Does anyone have any insight?
TIA. 🙂
Recently acquired a ZF7982, factory reset it, and am using it as a standalone ap.
It is currently running the most recent FW: 9.6.1.0.15
If I set up a 2.4 or 5 ghz network, give it a name, change some settings, then enable wpa2, psk, aes and give it a password and hit update, it reloads the page and then blanks out all of the information, like the attached screenshot.
After that I cannot update or edit any of the settings and the only way to make it work is to factory reset the ap.
Does anyone have any insight?
TIA. 🙂
