ZF7982 AP unable to setup wireless

[Anonymous]

Hi guys any help with setup, Logged in to set up the wireless but could not find where to enable the radio to set up my wireless, attached screenshot if anyone can help .planning on using it as standalone AP

[Anonymous]

I believe previously this AP is controller managed. You need to use standalone AP firmware to use it standalone mode.
https://support.ruckuswireless.com/software/793-standalone-ap-software-9-8-3-0-14-all-aps

[Anonymous]

All good to go Thanks, Gupta.
That was too easy 

[Anonymous]

or https://support.ruckuswireless.com/software/1017-zoneflex-solo-access-point-104-0-0-0-1347-ga-softwa...

[Anonymous]

A little confused here what's the difference between 9.8.30.14 all aps vs Solo access point 104.0.0.0.1347 g