Trying to assign new IP address/subnet and it keeps reverting back to previous address

[gnussbaum]

Not sure what/s going on here...I've tried setting the new IP and subnet through both the web interface and cli and it keeps reverting back to the original address.  Any ideas why?

[Parik_MN]

Hello @gnussbaum, 

Could you please elaborate your query? Are you trying to set IP address to AP? Could you share the steps you tried in detail?

Regards,

Parik

[gnussbaum]

1. Go to Unleashed dashboard.of device and change ip and subnet.  Click Accept.  Deive reboots and doesn't take the change

2. SSH into device.  Run set ipaddr wan <ip> <netmask> <gateway>.  SSH is no longer accessible as I assume it was setting the new address, but after a few minutes it reverts back to the old address.

I do this to four access points.  Same result for all.  Only the original managed access point took correctly.  Now I only see that 1 access point up and four disconnected.

This is an example:

IP Address

10.1.0.55

External IP:Port

10.10.1.52:12225

The IP address is the old one and the external is the new one. 10.1.0.55 isn't changing.

[gnussbaum]

I fixed it.  I didn't make the original changes from the master.  I reset it back and made the changes.  All good now.

[Parik_MN]

Good to know it fixed thanks @gnussbaum. 

Regards,

Parik