cancel
Showing results for 
Search instead for 
Did you mean: 

The indoor R510 APs reboot from time to time giving the error message "AP lost SCG more than 7200 seconds "

lefhoko_radisak
New Contributor III
The indoor R510 APs reboot from time to time giving the error message "AP lost SCG more than 7200 seconds ". APs are managed by a Virtual Smartzone Essentials, 3.6 version. Have someone experienced this error before and what is the solution to this?
6 REPLIES 6

sunny_gupta
Contributor II
Hi There,
This is expected behaviour per default settings.  You can change the timer, but 2 hours is the default if the AP cannot reach the controller for it to reboot itself in an attempt to resolve connectivity issues.

You should be able to change this in the controller, under access point group configuration. AP Reboot Timeout.

Cheers,

lefhoko_radisak
New Contributor III
My worry is what might cause the AP not to reach the controller?

hyosang_choi
Valued Contributor
You have to find the reason on wired side.

sunny_gupta
Contributor II
Yes, so that is a bigger question and would require reviewing system logs, etc. to determine why the AP lost connectivity in the first place.  It is most likely a network issue somewhere.

I'm assuming the controller did not go down for an extended period?  Was any client connectivity affected prior to the reboot taking place?  Are both the controller and access point on the same LAN?  If the controller is in the cloud, you must ensure the public IP (Control NAT IP) is configured to be sent to the AP otherwise it will only look for local private IP and never reach the controller.

Best bet is to work with your VAR to help determine the issue.  If it is Ruckus networking hardware, you could also engage our TAC.