TP-Link TL-WR902AC in Client mode not connecting to SZ100 R500 APs

[peter_riederer_]

Hi,
we want to use a TP-Link TL-WR902AC Wireless Travel Router setup in Client-Mode connecting to our Ruckus WiFi Infrastruktur (SZ100 with R500 APs) getting a wired Copy-Device wireless.

I can scan the Wifi-Networks on the TP-Link client and the networks are available, but it is not connecting. There are also no entries in SZ100 Log shown where any connection attempt of the client are made

SZ100: 3.5.1.0.862
AP Firmware: 3.5.1.0.490

Any hints, or other people who tried a similiar setup?

Regards

Peter

[peter_riederer_]

Thank you Michael, but its still not working.
Pushed the setting to one of my APs next to my desk, but i still cannot connect. even if i set the Bridge to Client or Repeater Mode. And it also doesnt matter if i use DHCP on the Bridge or set a static ip.

Also tried now a TL-WR802N (2,4 Ghz only) Nano Router, but still the same.

[alan_daniel_cha]

I have the same issue, works with static ip but dhcp never works. I try: set qos directedDHCP disable but not work. any suggestions ?

[garry_jones_bka]

Who has been able to sample the various products on this list and can be able to pick out the best one?
https://buywirelessrouternow.com/best-wireless-travel-routers/