cancel
Showing results for 
Search instead for 
Did you mean: 

T series/ R700 reboot PoE switch will can't boot up

td_td
New Contributor III
Any person has similar experience?
I am using Cisco switch with T300 series AP and R700 AP with SCG
Recently some of the AP will can't boot up after reboot the PoE switch
Some of them will return to original firmware from ZD
Some of them will return to original firmware from SCG
13 REPLIES 13

michael_brado
Esteemed Contributor II
Please provide your AP firmware version and switch model/firmware version to Tech Support,
as we'd like to see a reproduceable issue too.

td_td
New Contributor III
The cost found is cli script problem and the cli script already upload on another post

td_td
New Contributor III
fw_version=3.0.4.0.461
model=all

set blacklist wifi1 52 -1

set blacklist wifi1 56 -1

set blacklist wifi1 60 -1

set blacklist wifi1 64 -1

set blacklist wifi1 100 -1

set blacklist wifi1 104 -1

set blacklist wifi1 108 -1

set blacklist wifi1 112 -1

set blacklist wifi1 116 -1

set blacklist wifi1 120 -1

set blacklist wifi1 124 -1

set blacklist wifi1 128 -1

set blacklist wifi1 132 -1

set blacklist wifi1 136 -1

file b

fw_version=3.0.4.0.461
model=all

set blacklist wifi0 2 -1

set blacklist wifi0 3 -1

set blacklist wifi0 4 -1

set blacklist wifi0 5 -1

set blacklist wifi0 7 -1

set blacklist wifi0 8 -1

set blacklist wifi0 9 -1

set blacklist wifi0 10 -1

set blacklist wifi0 12 -1

set blacklist wifi0 13 -1

michael_brado
Esteemed Contributor II
Thanks,

You don't need the line "file b" or the second re-definition of the fw version.

You should add a "reboot" command to the end.

td_td
New Contributor III
It is two separate file one for 2.4g another is 5g so u mean each of it should add reboot at the end ?