A section in this doc, which says R600 is supported, also has other advice, to run 104 Solo AP code, and to disable LWAPP2SCG service. Here is that blurb with config info that might help:
On solo APs running releases 104.x and higher, the LWAPP2SCG service must be disabled. To disable the LWAPP2SCG service on an AP, log on to the CLI, and then go to enable mode > config > lwapp2scg > policy deny-all. Enter Yes to save your changes
Otherwise, I want to know about your network. Can your APs communicate with your vSZ controller? There are ports necessary for AP - Controller communications, per the Admin Guide:
Thanks for the support and advice but we still failed to get AP to the controller.
Here are the details from the beginning: Unleashed firmware 184.108.40.206.64.bl7 was first inserted into the AP R600. We then inserted the standalone firmware 220.127.116.11.1347 and after that 18.104.22.168.695 vSZ firmware. AP was not coming to the controller so we inserted 22.214.171.124.675 standalone firmware. After that we noticed a message: State: CONN_GET_ADDR_STATE We tried AP CLI command: set scg ip but without change. Then we sent a question.
Now we have tried your advice but failed to disable LWAPP2SCG service on AP.
Here "get scg" output:
------ SCG Information ------ SCG Service is disabled. AP is not managed by SCG. AP is not registered in SCG. State: Not Available - busy or not running. SCI is disabled. Server List: Not found No SSH tunnel exists Failover List: Not found Failover Max Retry: 2 DHCP Opt43 Code: 6 Server List from DHCP (Opt43/Opt52): 172.28.11.21 SCG default URL: RuckusController SCG config|heartbeat|mesh status|status intervals: 300|30|300|900 SCG gwloss|serverloss timeouts: 1800|7200
We tried enable disable scg but it's the same again.
If it makes sense I think that AP somehow lost configuration for the tunnel (when we were changing the firmware) so it can't come to the vSZ staging zone.
How can we check the ports for communication with the VSZ? We will open support ticket if you suggest it?
Hi Janko, Yes, please open a case and let us know. I have similiar problem in my office lab, can't get Unleashed R600 onto our Cloud Wi-Fi, after going thru 110 and 104 Solo images, even SZ 3.6.2 firmware. Our TAC team can help collect Unleashed logs and AP details (might take remote access?), and will know where to look in the AP scg details. My R600 had been on Unleashed 200.6 before I factory defaulted and started changing images. And what is the Serial Number of the AP whose info you provided above please? We have an AP registrar that points APs to controllers, if they have been setup for Cloud management, etc.