Speed Throttling
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-05-2018 02:18 AM
Recently purchased two R510 for my home connected through a gigabit switch to a router. Cat6 wiring all around. Connection speed is 200mbps. I am able to get 180mbps down when connected to the router. When i connect to the Ruckus, the speed seems to throttle exactly at 50mbps down. Any solutions ?
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2019 09:34 PM
UPDATE: So I'm currently getting around 110Mb/s up and down on 2.4GHZ and 450Mb/s up and down on 5GHZ. Quite happy with the 5GHZ speed but still not able to figure out what I can do to improve the 2.4GHZ band.
UPDATE2: So i finally managed to upgrade both the APs to the Unleashed firmware. I've created one as the Master AP and deployed a secondary AP and have only a single SSID. Now I'm getting a throughput of 350MB/s up and down which is the maximum of the 2.4GHZ band for the R510. How do I create a separate SSID with 5GHZ band to get its max throughout ?
UPDATE3:: So i found a way to use just 2.4GHZ only but then it goes back to 100Mb/s. Looks like it was using 5GHZ.
UPDATE2: So i finally managed to upgrade both the APs to the Unleashed firmware. I've created one as the Master AP and deployed a secondary AP and have only a single SSID. Now I'm getting a throughput of 350MB/s up and down which is the maximum of the 2.4GHZ band for the R510. How do I create a separate SSID with 5GHZ band to get its max throughout ?
UPDATE3:: So i found a way to use just 2.4GHZ only but then it goes back to 100Mb/s. Looks like it was using 5GHZ.