Ruckus Unleashed Dashboard not reachable

[stot]

I have a Ruckus R320 configured and working. It acts as a wifi end point (no DHCP). I know its ip address but when trying to connect to this ip I just get an unreachable message. Ping is working and I can connect via ssh.

Thanks

[sanjay_kumar]

Hi,

Is it running on the Unleashed version? If yes, see if you can login to the CLI and check the below commands:
If it is a master then you should get "ruckus#" as soon as you login.
If not you will get "rkscli:"
If it is not a Master then you will not get the GUI access.

If the AP is not running on the unleashed, probably you can use the command "set https enable" and see if the GUI is accessible.

[stot]

Thanks for your answer.

Yes its unleashed. I installed this firmware 118.2.0.0.875.bl7 without further configuration besides wifi.  Its not a Mater (got rkscli: after login).

The R320 is the only Ruckus AP in the network. As far as I understood the first AP will always be the Master. So it should be Master then?

Is there a way to change into master mode without resetting? 

Thank you very much

[sanjay_kumar]

Hi,

118.2.0.0.875.bl7 is not a Unleashed version, it is standard version. Use the below command to enable the https and then try to access the GUI.
rkscli: set https enable