I installed 2 Ruckus R510 at a client who is now 600km away and during the installation it failed to give me access to the Access Point after setting it up. I had to physically reset it. Now I, back at the office(not at the clients site) and it allowed me access to the Access Point once then I updated it to the new Unleashed Firmware and it rebooted properly. After it rebooted I was able to login in once and then afterwards when i tried to change the SSID it wouldn't let me login after rebooting...
I don't want to travel 600km for an access point, is there anyway this can be resolved without having to physically reset the AP?
Solved! Go to Solution.
Could you please confirm if you are getting the WebUI page for the unleashed controller ? Are you getting any error while login into the Web UI?
Please try to login into the unleashed controller CLI via SSH/Putty with same credentials which you have setup during the unleashed configuration.
From CLI you can use the command #set factory and #reboot the AP.
Thank you for the update and glad to hear that the issue is sorted out.
The default credentials for the AP based on the software version are as follows:
Standalone version : User name - super, Password-sp-admin
Unleashed : Username - admin, Password-sp-admin
Please feel free to let us know if you need any assistance.