R850 Mesh Support in SmartZone

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Does the R850 Support Mesh in SmartZone as Root AP or Mesh AP?

I had two separate occasions, one with vSZ v6 and one with SZ124 controllers on v6.2, where I tried to deploy a mesh with R850 APs but failed.

All R850 APs were provisioned via cable connection and all automatically took the RAP / root AP role. Then one R850 was disconnected after provisioning and powered via PoE injector, while still being very close to another AP that showed as root AP.

However, the AP that is now connected via injector did not connect via Mesh to the other APs.

Mesh was of course enabled (both mesh and Zero Touch Mesh)

Any ideas? Is this R850 specific?

1 REPLY 1