Hey everyone,
I'm new to Ruckus hardware but experienced with networking, particularly with Netgear and Unifi products. I recently got two free Ruckus R750 APs from work and have a Unifi switch with three VLANs set up (in addition to the LAN).
I know I need to configure the the switch to allow the specific VLANs, but I can't find any VLAN settings in the configuration page. Also, I want to set one of the APs in bridge mode because my router is on a different floor than my home lab. I need the second AP to function as an Ethernet port for my switch in the lab, similar to my current Unifi setup. The AP as been reset, is online and has the default firmware.
Any pointers would be greatly appreciated. Thanks!
