P300 Communication Status in SCADA

[vaitheeswaran_e]

I am using P300 Root and Non-Root bridges. I need to take the communication status and the signal strength in the SCADA(Wonderware Intouch) without logging in the browser. Please suggest an solution for this!!!!!!!!

[syamantakomer]

Hi Vaitheeswaran,

If your SCADA system supports SNMP integration then you can use it to pull the stats from P300.

Here is the link for P300 MIB file which you have to add in your server and setup SNMP.

https://support.ruckuswireless.com/software_downloads/983-zoneflex-p300-ptmtp-ap-bridge-mibs-for-ver...

Make sure that you enable SNMP on P300 bridge as well.


Regards,
Syamantak Omer

[sanjay_kumar]

Hi Vaitheeswaran,

If you want to use SNMP, try with the below OIDs.

WLINK RSSI : .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.11
WLINK Uptime : .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.10
WLINK Role : .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.2

[vaitheeswaran_e]

Hello Syamantak,

I am using Wonderware Intouch Software as SCADA. It supports SNMP Integration, Please check the below link it's for configurating the Bridges with Wonderware using System Management Console. I need to take the Connection Status( Whether the bridges are connected or not) and Signal Strength of the Bridge as a graphical representation. Please guide me how to take the datatype for the Connection Status and Signal Strength.

https://www.logic-control.com/datasheets/1/Device%20Connectivity/OI%20Servers/SNMP%20OI%20Server%20U...

[syamantakomer]

Hi Vaitheeswaran,

As suggested by Sanjay in his previous comment, please use below SNMP OIDs to pull the required details.

WLINK RSSI (Signal Strength) : .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.11
WLINK Uptime (Connection status): .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.10
WLINK Role : .1.3.6.1.4.1.25053.1.1.15.1.1.1.1.1.2

Let us know if that answers your query or you have any further queries.

Regards,
Syamantak Omer