Mesh mode ZD1012 and ZF7363

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Hi. I have a network with wich consists of 25 APs ZF7363 and controlled by ZD1012. The network is maxed out with APs, but i still have some dead spots and was wondering if i could use mesh mode.

My qustions is:

- If i enable Mesh in the ZD1012 will i then loose speed over all?

- After i have enabled Mesh overall, can I then just enable mesh on the specific AP?

- How do I setup mesh mode?

Hope you can help me.

1 REPLY 1