Issues with https admin portal on a 7982

[fbcsysadmin]

I have a new ruckus 7982 that I'm using as a standalone AP. For the most part everything is working fine but when I log to configure the settings using the "https" portal I run into a random issue that slows things down.

Basically it says "establishing secure connection" on the bottom of the web page and cycles for 5 to 20 secs before it lets me through to the config page, this is completely random and can happen at any point where I change tabs or issue changes, it can also not appear for several min before coming back and bugging me again. Turning the https portal off and using the http portal works fine, but I would prefer to use the https portal for obvious reasons. I have already tried multiple firmware updates, including 9.6.0.0.* which has worked fine for me on other APs. I do not have a zone-director, thanks for your time and help on this issue.

[fbcsysadmin]

Okay, I did a factory reset again and managed to get in and everything seems to be working properly without any of the before mentioned issues. I think I had to do a restart of the machine as mentioned previously due to the fact that I already had a 192.168.0.1 device on my network so the duplicate IP probably sent it spinning until I restarted it without a network connection.

I'll keep an eye on the AP and may go through an RMA but will try to avoid that unless I have to, thanks for helping me out.