Hello,
I tried to set controller address in 2 different APs (7343 and P300) via web interface and I was unable to. I get the confirmation message, saying that my parameters were saved, but nothing happens.
See below the images with the issue:
Is this normal behavior? Or can only be done by CLI?
Regards.
I tried to set controller address in 2 different APs (7343 and P300) via web interface and I was unable to. I get the confirmation message, saying that my parameters were saved, but nothing happens.
See below the images with the issue:
Is this normal behavior? Or can only be done by CLI?
Regards.
