I run an office with about 80-100 users (maybe 120-150 devices of laptops/phones). I'm currently using 2 Netgear R7000s behind a pfSense device and it's OK with some slowness. I decided to try adding a Ruckus R700 after a recommendation from a friend to see if I could replace my infrastructure with Ruckus stuff but have been very disappointed with it's performance out of the box.
1. Can someone explain the versioning system to me? I see 9.8.x, 9.9.x, 9.12.x and the 100.x line of firmware. If I want to run the R700s behind the pfSense as routers which firmware should I be using the maximize stability? The release notes aren't that helpful.
2. I've turned off SmartSelect since it was constantly jumping and dropping connections. However, I still see behavior where all the 5G connections will just die (the router is still reachable if I jump onto a R7000 and connect to the web interface).
I've played around with some wireless configuration options (hardcoded channel, 20, 40, 80 Mhz) without any luck resolving the stability issues. It's hard for me to believe that a $1k device can't outperform a $200 device so I'm assuming it's something on my end - would appreciate any advice or help to get these up and running.
I would recommend that you stick to 220.127.116.11.15 version as its a seasoned version with lots of fixes which brings in stabilty and enhanced performance.
9.8.x, 9.9.x, 9.12.x and the 100.x are various versions which your hardware supports. Years back they only had one platform or product line known as zoneflex so they had 9.8.x, 9.9.x, 9.12.x to support that. Now they have cloud platform too. keeping this mind they came up with 100.x which is interoperable with both platforms. Having said this and looking at your requirements stick to 18.104.22.168.15.
Hi Monnat Systems, thanks for the quick reply and the feedback on the right version to use. Curious what the other firmware versions are optimized for?
I'm not at the office right now so I can't test it but I'm sure that I set fixed channels for both 2.4 and 5g. Will double check when I get in tomorrow.
I don't understand about the DFS / RADAR detects. Are those something I would see in the logs?
As far as the questions:
- I've set up two networks (SSID and SSID5G) but in my space right now I have 2 additional APs (the Netgears). I'll connect just one or two computers to SSID5G on the Ruckus and eventually at some point I won't be able to connect to any sites or even the pfSense router though my Wireless still shows as connected. Then I'll switch to the Netgears and be able to login to the Ruckus' Web Admin panel.
- To recover from the problem, I'll switch the channel of the Ruckus, erase it from my laptop's wireless memory and reconnect and that'll reconnect. Reboot also works.
The only thing I would add to what Monnat said is that I would personally run the newest 100.1 firmware or at minimum 9.8.3. The original 9.8.0/9.8.1 firmware in standalone mode FOR SURE had some 5GHz connectivity bugs (especially multicast and broadcast traffic being dropped) in standalone mode that I've posted about and had worked with Support for a while to track down. It looked like it was eventually mentioned in later release notes as a resolved errata.
Once you're using such firmware, if you still run into connectivity issues, it would help to have more details about the client type. It is very surprising that it'd take something as drastic as forgetting the network and even changing the AP channel to get the client to connect again. The R700 has been very stable for me in standalone mode too, and in fact I also migrated from the Netgear R7000 for my home office.