FW upgrade issue
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-27-2020 07:12 AM
I have 30 H510 APs having unknown FW version and not registering in SmartZone. I have the correct FW downloaded but APs are not allowing access through web portal, TFTP or SSH. Please help me on FW upgrade.
12 REPLIES 12
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-30-2020 11:49 PM
Hi Nikita, I have done exactly as you said but still same. If there is no DHCP it is taking 192.168.0.1 but can't access with ssh or web portal. (When there is DHCP it is taking IP from the scope) All these APs are broadcasting Configure.Me-xxxxx SSID. I was able to connect to AP thorough WiFi but was not able to access the AP.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2020 01:11 AM
Hi Chamika, The following thread says that if an AP was managed by a controller before, it's web access will be disabled (http and https will be
disabled):
https://forums.ruckuswireless.com/ruckuswireless/topics/what-is-the-password-for-configure-me-ssid-a...
However, SSH should work...
Can you actually ping 192.168.0.1 when AP is isolated after hard reset with no reachable DHCP servers? If ping works and SSH doesn't (no response) then it's probably time for RMA.
https://forums.ruckuswireless.com/ruckuswireless/topics/what-is-the-password-for-configure-me-ssid-a...
However, SSH should work...
Can you actually ping 192.168.0.1 when AP is isolated after hard reset with no reachable DHCP servers? If ping works and SSH doesn't (no response) then it's probably time for RMA.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2020 01:34 AM
I can ping 192.168.0.1 but cant reached using SSH. I might go for RMA then.

