E510 DC Power

[roopesh_sheth]

I'm getting a couple of E510s for outdoor coverage.  I'm not running ethernet to them as I plan to use them in a mesh.  I will have 12V power to them.  There is an M8 connector for DC power, but I can't find a pinout or adapter for the DC power port.  Anyone know how I wire in the 12V power?

[DarrelRhodes]

Hi Roopesh,

You have my sympathy, this information was very nearly impossible to find!

One of my amazing colleagues in the UK went digging in our product technical archives and found a product specification document with the following noted on the very last page:

Pin1 => positive

Pin3 => Negative

The document is internal-use-only but I hope the above helps!

All the best,
Darrel.

[roopesh_sheth]

Thank you @darrel_rhodes and your UK team!  I look forward to getting this setup.  I hope the pins are labeled 🙂