08-27-2021 05:37 AM
I'm getting a couple of E510s for outdoor coverage. I'm not running ethernet to them as I plan to use them in a mesh. I will have 12V power to them. There is an M8 connector for DC power, but I can't find a pinout or adapter for the DC power port. Anyone know how I wire in the 12V power?
08-27-2021 08:41 AM
Hi Roopesh,
You have my sympathy, this information was very nearly impossible to find!
One of my amazing colleagues in the UK went digging in our product technical archives and found a product specification document with the following noted on the very last page:
Pin1 => positive
Pin3 => Negative
The document is internal-use-only but I hope the above helps!
All the best,
Darrel.
08-27-2021 10:20 AM
Thank you @darrel_rhodes and your UK team! I look forward to getting this setup. I hope the pins are labeled 🙂