cancel
Showing results for 
Search instead for 
Did you mean: 

Creating a MESH with multiple AP's

russell_perry_6
New Contributor II
I have recently bought in to Ruckus APs. Some config points below before the question
  • Initially, I was using a R310 200.7.10.202.94
  • I have now purchased 2x R610's
  • The internal IP range is 192.168.1.X 
  • The ISP router is 192.168.0.X
  • In between the WAN and Lan I have a Luxul ABR-4500 to manage LAN IP's
Issue
When booting up the R610 whilst in config mode I could not get a connection. Therefore I plugged them in to the computer and went direct to the deafult IP 192.168.0.1 (that's was assigned to my ISP fibre router. 

I altered the IP address and subnet of the first R610 to be in range of the R310 (Master - 192.168.1.161) and used 192.168.1.160 for the R610

When logging back in to the unleashed UI under 192.168.161. I can not add the new R610. Its just not appearing

Question
Should I have MESH enabled on te R310 or is there another way to add the R610 to the Unleashed AP's?

Thanks for your support.

Regards

Russell
8 REPLIES 8

phil_coverdale_
New Contributor III
Hi Russell,

The R310 AP does not support mesh.

Regards,

Phil.

russell_perry_6
New Contributor II
Quick response, which is always great to see! So would you suggest I get rid of the 310 and just use the R610s on their own?

phil_coverdale_
New Contributor III
Hi Russell,

Is it possible for you to connect the R310 to your network by Ethernet cable?

Regards,

Phil.

russell_perry_6
New Contributor II
Yep, thats possible