Basic AP Install

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Can I configure a T350SE out of the box as a standalone AP (basic setup, no ZD, no controller, just plain old Wi-Fi) without any issues down the road? I currently have the SSIDs programmed the way I want them, but the CTL light is still blinking (because it's looking for a controller). The AP works as is, but I want to make sure I'm not going to run into issues later because it's still looking for a controller. I have browsed the firmware selection but I'm not sure which one I would use for just a one-off AP install that doesn't need to be linked to other APs or connected back to a controller, ZD, etc.

Any insight would be great. Thank you.

1 REPLY 1