Basic AP Install

[NXGServices]

Can I configure a T350SE out of the box as a standalone AP (basic setup, no ZD, no controller, just plain old Wi-Fi) without any issues down the road? I currently have the SSIDs programmed the way I want them, but the CTL light is still blinking (because it's looking for a controller). The AP works as is, but I want to make sure I'm not going to run into issues later because it's still looking for a controller. I have browsed the firmware selection but I'm not sure which one I would use for just a one-off AP install that doesn't need to be linked to other APs or connected back to a controller, ZD, etc.

Any insight would be great. Thank you.

[aswin_dasari]

Yes, T350SE can be configured in Standalone mode on firmware version 118.2.0.0.875(latest) or 116.0.0.0.3136. By default, AP may try to discover the Controller and we can disable this. Please confirm the current firmware version on AP and share the output of below commands from AP CLI to verify the current status and disable if required.

rkscli: get discovery-agent
rkscli: get scg
rkscli: get hub

Thanks,
Ashwin Dasari.