2nd cable causes wireless clients to not be able to connect r510

[kortney_monah]

I am testing a ruckus 510 in standalone mode V: 106.1.0.0.469 I have managed to set it up fine, plugged into a POE switch and it works great with one cable as soon as I plug a 2nd cable in I cannot connect to the AP from any wireless device. Both Ethernet ports are enabled and set up the same

Trunk Port

Bridge to WAN

802 disabled

VLAN 1

Am I missing something?

Thanks.

[alex_alex_4xiis]

 Make sure your AP model supports it and make sure the switch it is connected to is also set up correctly for link Aggregation. for looking into it and your quick response was driving me mad last couple of days! 
https://testmyspeed.onl/
https://scrabblewordfinder.vip/
https://solitaire.onl/