System ZD 1100 USB
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2016 04:42 AM
Hello
I format the USB key which is located at the inner casing of ZD 1100 helped me how can I repair my zone director
I format the USB key which is located at the inner casing of ZD 1100 helped me how can I repair my zone director
29 REPLIES 29
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-13-2019 05:00 AM
Thanks Dan, As I stated above, managed to revive dead ZD1100 by cloning another working USB,
So the vintage USB worked when cloned, but no good trying FDISK rescue mode.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2019 11:34 AM
That's awesome. I'll be trying that here in the next couple days.
Also, to confirm: I just got the first of two used ZD1100's in today. It had 9.8.x installed. I downgraded to 9.7.x, then upgraded that to 9.10. It's deployed and working fine.
Also, to confirm: I just got the first of two used ZD1100's in today. It had 9.8.x installed. I downgraded to 9.7.x, then upgraded that to 9.10. It's deployed and working fine.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2019 01:32 PM
Just to follow up - I successfully cloned the stock USB drive using dd. I made an image file as a backup, then wrote that out to a new, generic 4GB stick. Works perfectly. With any luck, wear-leveling will make it last longer than the original.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2019 11:59 PM
Did you have a valid service contract on the ZD1100 you upgraded to 9.10?
I was told the 9.10 checks for this before letting you upgrade.
(I just bought a used ZD1100, and am trying to find the latest fw I can use)
-jannis
I was told the 9.10 checks for this before letting you upgrade.
(I just bought a used ZD1100, and am trying to find the latest fw I can use)
-jannis
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-28-2020 01:19 PM
Daniel I'm tinking about buying a zonedirector 1100 that powers on but won't boot on ebay for my R600 and r700 to coexist properly at home. I presume that it was pulled from a working environment and hard reset for too long. Would it be possible to get your cloned image as you've had success so I could just switch out the USB? Thanks Richard

