changed our ip address and forgot to set the access point ip's

[gnussbaum]

Now I can't get to the web interface. What options do I have to go in and change the ip's?

[Ayush_Tripathi]

hello @gnussbaum 

How many AP into the setup ?

Are you trying to connect the AP to the unleashed controller ? Please confirm the AP mode ?

Factory default the AP by holding in the reset button for 10 seconds. This will reset the APs IP address to 192.168.0.1.

Configure a 192.168.0.x (other than .1) on the PC Ethernet interface:
     -  Go to the start button on your PC and click on control panel.
     -  Click on Network and Internet and then Network and Sharing center.
     -  On the next screen click on "Change Adapter Settings".
     -  On the next screen Right mouse click on the Ethernet adapter and then choose "Properties".
     -  On the next window scroll down to "Internet Protocol version 4(TCP/IPv4)" and double-click, to bring up the next window.
     -  Change the setting from "Obtain an IP address automatically" to "Use the following IP address".
     -  In the next line down enter the IP address 192.168.0.20 and use a subnet mask of 255.255.255.0, and click OK.
        (Remember to change the auto IP address setting back when done working with the AP).