cancel
Showing results for 
Search instead for 
Did you mean: 

No Primary or Seconday Image

bob_builder_dxz
New Contributor II
One of our users has accidently wiped our Brocade Fastiron 624p Switch. It comes up to boot cli but has no primary or secondary image. How do I get a flash image back on this switch?
25 REPLIES 25

techhelp24
New Contributor III
you can reload the firmware via TFTP

netwizz
Contributor III
That is a very old switch that is End-of-Life, so the best option would be to replace it with a newer ICX such as the ICX-7250-24P or ICX-7150-24P.

At any rate, if you want to do a recovery, I am not certain which port you would connect it to the network to do TFTP to it.

That said, these commands should ultimately work:

http://docs.ruckuswireless.com/fastiron/08.0.70/fastiron-08070-upgradeguide/GUID-DA75FD7E-A8D4-4B12-...



bob_builder_dxz
New Contributor II
Unfortantly those commands are not working. This is my starting point.
Image_ images_messages_5f91c43a135b77e2479cfb50_a842db8fd86444de32f10b3bace26c0f_RackMultipart2019012362991d78h-77eb2fb8-2ca9-43ff-9408-dc8ffcd43c27-1564674584.PNG1548271266

netwizz
Contributor III
What do you have if you type a ?

"question mark"