No Primary or Seconday Image

[Anonymous]

One of our users has accidently wiped our Brocade Fastiron 624p Switch. It comes up to boot cli but has no primary or secondary image. How do I get a flash image back on this switch?

[Anonymous]

you can reload the firmware via TFTP

[Anonymous]

That is a very old switch that is End-of-Life, so the best option would be to replace it with a newer ICX such as the ICX-7250-24P or ICX-7150-24P.

At any rate, if you want to do a recovery, I am not certain which port you would connect it to the network to do TFTP to it.

That said, these commands should ultimately work:

http://docs.ruckuswireless.com/fastiron/08.0.70/fastiron-08070-upgradeguide/GUID-DA75FD7E-A8D4-4B12-...

[Anonymous]

Unfortantly those commands are not working. This is my starting point.

[Anonymous]

What do you have if you type a ?

"question mark"