This question is in relationship to a the
r700 which is support all the way down to 9.8 GA.
It may be down to the AP's being in a remote location
Provisioning loops can be caused by one of the 2 following
issues:
1. MTU
Solution:
Set the LWAPP MTU to 1250
2. QoS
settings on ZD
ruckus> en
ruckus# config
You have all rights in this mode.
ruckus(config)# system
ruckus(config-sys)# qos
ruckus(config-sys-qos)# show
System QoS:
ToS DATA TUNNEL = 0xA0
ToS CTRL TUNNEL = 0xA0
ToS Classification-Voice = 0xE0 0xC0 0xB8
ToS Classification-Video = 0xA0 0x80
ToS Classification-Data = 0x0
ToS Classification-Background = 0x0
Tx fail threshold = 50
heuristics inter-packet-gap Video = 0 65
heuristicsinter-packet-gap Voice = 15 275
heuristics packet-length Video = 1000 1518
heuristics packet-length Voice = 70 400
heuristics classification Video = 50000
heuristics classification Voice = 600
heuristics no classification Video = 500000
heuristics no classification Voice = 10000
Solution:
The values highlighted need to be set are per
the below:
ToS DATA TUNNEL = 0x00
ToS CTRL TUNNEL = 0x00
This can be done using this command:
ruckus# set_qos sys tunnel-tos-val data 0x00
and
ruckus# set_qos sys tunnel-tos-val ctrl 0x00
It is mainly caused when 3rd party switches can have
traffic marked differently and prevent the AP from taking their config.
