Unleashed to Standalone R600 fails

[michael_abadjie]

Reflash from R600 Unleashed to Standalone fails. After 45 minutes on the chat/phone with support, they provided article on how to reflash from Unleashed to StandAlone R600. Everything went well and I've got a message that the firmware was flashed successfully but 2 of the units are not responding at all - steady green light, hard reset goes from Red to Green immediately only power light is on, nothing else. Any hint/ideas will be greatly appreciated. Quite frustrating experience...
Thanks,
Michael Abadjiev

[michael_brado]

Factory Default the AP after changing firmware.

[michael_abadjie]

Do you mean push the pinhole for 10 seconds? I did this more than a dozen times. It boots and the power light changes from Red to Green - that's all. I RMA the units however.