This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject

 

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

 

Ruckus Wireless
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Ruckus R710 Networks don't show up after reset. Configure.me just shows up again

Go to solution
DEvans
New Contributor

‎04-26-2022 08:50 AM

Title covers it really. I hard reset my AP in order to turn off Gateway mode. Upon reboot I was having a lot of trouble accessing it over ethernet at 192.168.0.1.

 

However I could see the configure.me network so set it up using this. The setup goes normally until the reboot, at which point the network created during setup does not show up on a nearby PC but the configure.me network pops back up.

I can access this network and enter the admin panel, but it looks normal. It says it is broadcasting the network which does not show up and creating a new network does not solve the issue. 

 

Any ideas?

0 Kudos
Reply
1 ACCEPTED SOLUTION

Go to solution
DEvans
New Contributor

‎04-26-2022 09:09 AM

Ah, think I was getting a setup stage wrong. I was selecting 'DHCP' instead of 'Manual' - although I'm not sure why this caused what I saw. 

View solution in original post

0 Kudos
Reply
1 REPLY 1

Go to solution
DEvans
New Contributor

‎04-26-2022 09:09 AM

Ah, think I was getting a setup stage wrong. I was selecting 'DHCP' instead of 'Manual' - although I'm not sure why this caused what I saw. 

0 Kudos
Reply
Copyright © 2026 Khoros, LLC