Ruckus R650 with Unleashed 200.16.7.0.402 has broken Web UI

[netconductive]

Hello! I have a Ruckus R650 [901-R650-US00] running Ruckus Unleashed (200.16.7.0.402) and the Web UI is broken. Though it loads up initially just fine, whenever I try to edit a Wi-Fi network or click on the "access points" section it just loads an empty grey screen. Here are some relevant logs that I found in the syslog:

```
Sep 6 13:10:11 prd-radio syslog: upgrade_debug: pid=5161, insert_field_to_upgrade_ap_list(): firmware_file open failure
Sep 6 13:10:11 prd-radio syslog: upgrade_debug: pid=5161, get_ap_list(): see [/tmp/unleashed_upgrade/upgrade_ap_list_from_election.xml.ready], ap-list ready!
Sep 6 13:10:11 prd-radio syslog: upgrade_debug: pid=5161, get_ap_list(): ap-list loop 0.
```

That's my first problem with it. My second problem is that it won't negotiate 802.3at (POE+) no matter what I try. I'm powering it with a Juniper SRX320-POE, and I have enabled POE negotiation on the source but it still recognizes it as a "802.3af Switch/Injector":

```
ruckus(ap-mode)# get power-mode
PoE Configured Mode : Auto
Power Consumption Status : 802.3af Switch/Injector
USB Status : Disabled
OK
```
Forcing it to use POE+ with `set power-mode at` works, but doesn't persist after reboot.

Finding what the log messages mean has been a big pain as documentation that refers to it is almost non-existent.

Thank you

[yogesh_giriyapp]

Hello,

I believe this could be a firmware corruption, however, if the issue is seen on a single AP, try to factory reset the AP and when you get to the initial configuration screen, upgrade the AP using the same firmware version, then reconfigure it.

RUCKUS Unleashed AP 200.16 (GA) Refresh Software for R650 | Software Downloads | Ruckus Wireless Sup... - link to download firmware

If the issue continues to occur, you have to create a case with Ruckus Support with all the details so that AP can be replaced.

Regards,

Yogesh G