R600 Not Connecting to vSZ

[brian_campbell_]

Hey,

I'm trying to connect two R600's to my Virtual Smartzone and am not having any luck.

I run the commands 

>set scg ip 172.16.4.70
>set director ip 172.16.4.70
>reboot

Upon rebooting, the vSZ has no indication that it has found these new Access Points.

I'm pretty sure that we are on the same subnet and when I ping the Controller IP address from the R600s, I get a response.

Thanks

[victor_gonzalez]

Hi Brian, what version of vSZ are you running?

Regards

[matthew_glaser]

Try a different stand alone firmware on the R600s.  I use Release 104.0.0.0.1347 (Solo AP).  Then if it does not show in the SZ, do your set scg command and it will show up.

[brian_campbell_]

The current vSZ version that I'm using is : 3.4.1.0.208
The R600 versions are : 110.0.0.0.675

I'll try and see if downgrading to 104 will help with the problem

[brian_campbell_]

It turns out upgrading to 104 from 110 allowed my R600 to be found almost instantly in the virtual SmartZone, thank you guys.