cancel
Showing results for 
Search instead for 
Did you mean: 

Mesh AP wired client isolation

richard_little_
New Contributor
I have ZD controlled AP models 7962 and 7055 where the 7962 are root APs and 7055 are mesh APs with wired ports for client in room use. I have checked both boxes for client isolation in the WLAN settings and have a whitelist for the guest gateway on the network. It does not appear that client isolation is working as the wired client on MeshAP01 is able to ping another wired client on Mesh AP02. Is it possible to isolate these wired clients?
2 REPLIES 2

gupta_pallapot1
New Contributor III
Wired clients cannot be isolated as per my knowledge.

richard_little_
New Contributor
Thank you for the reply. That was my observation even after adjusting ACLs in the ZD. As this was my first time with this scenario I figured I'd put my question out for the community.