cancel
Showing results for 
Search instead for 
Did you mean: 

Login AP WebUI from controller

irvan_irvan_64v
New Contributor III
Hi, there is possible to open AP WebUI from controller Smartzone100 ? i already try connect to ip AP, but the AP WebUI cannot open.
2 REPLIES 2

abilash_p_r
Contributor
Hi Irvan,

When AP connects to SZ/vSZ, AP's web interface would be disabled. It is disabled, to save its memory; below is the output from AP's CLI.
Please login: admin
password :
Copyright(C) 2016 Ruckus Wireless, Inc. All Rights Reserved.
** Ruckus R710 Multimedia Hotzone Wireless AP: 351603804913
rkscli: get https
HTTPs access is enabled
But the service is off, it is turned off to save memory once AP is managed by SCG!
If you need the service, please enable again by command "set https/http enable"!
OK
rkscli:
If you want to enable it please run "set https", but it is strongly recommended not to enable it.

Regards,
Abilash PR.

Hi Abilash, ok i understand. Thanks for your support 🙂