Is there any additional configuration needed to enable this LAN port?

[Natthakrit]

I am using an R610 connected to a Power Injector for power supply, with the other end of the Injector left unconnected. The R610 is configured for mesh networking to connect to the network. I am trying to connect a notebook to the LAN port on the R610, but the port is not coming up, preventing the notebook from connecting. Device details: - Controller: Ruckus SmartZone 1200 - Access Point: Ruckus R610 Is there any additional configuration needed to enable this LAN port? Please advise if there are specific settings required to get this port working.

[vasanth_edward]

Hi Natthakrit,

Thank you for contacting RUCKUS Support via the Community Forum.

As per the R610 datasheet (https://webresources.ruckuswireless.com/datasheets/r610/ds-ruckus-r610.pdf), for the LAN1 port to function properly, the Access Point must be powered using 802.3at (PoE+).
Kindly ensure that the AP is receiving adequate power.

Did I answer your query? If yes, hit the Kudos button and also accept the answer as
Accepted solution.