How to enable R610 Port 2 and configure as Link Aggregation on Ruckus-Unleashed?

[leo_chung_fsn1v]

Dear all,

Does anyone can help to enable the Port 2 on R610 (picture as below) and how to use it as Link Aggregation?  Thanks a lot!

[Ankush_Chandan]

Hi Leo,

Please refer to following article on instructions on how to configure LACP.
https://support.ruckuswireless.com/articles/000006007

You can also refer to the AP admin Guide for details. Instructs are on page#115:
https://support.ruckuswireless.com/documents/2404-ruckus-indoor-ap-110-0-user-guide

Please ensure that AP is powered using 802.3at PoE+ for it to enable the 2nd eth.

Regards,
-Ankush

[leo_chung_fsn1v]

Hi Ankish,

Thanks for your reply, but I cannot find the AP admin Guide from the link you provide https://support.ruckuswireless.com/documents/2404-ruckus-indoor-ap-110-0-user-guide and I also cannot search the AP admin Guide on Ruckus R610.  So would you please help to capture the instruction from the Guide or tell me the directly download link?

Also, does any way can enable LACP from GUI (graphical user interface) because I don't really know configure from comment line.

MANY THANKS AGAIN!

Best regards,
Kevin

[Ankush_Chandan]

Hi Leo,

You have to login to your support portal account to see the User Guide. I hope you have an account.

Regards,
-Ankush

[leo_chung_fsn1v]

Hi Ankush,

Surely, I have the support portal account but my problem is cannot find the AP admin Guide.  Please see below:



Also, would you please tell me "does any way can enable LACP from GUI (graphical user interface)"?  Because I don't really know configure from comment line.

Thanks again!

Regards,
Kevin