How to check if BeamFlex+ is enable on R770?

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

I recently replaced an old access point with a R770. However, i hasn't noticed any improvement in performance compared to the old setup-especially in weaker coverage areas like corners of the building.

I'd like to know how to verify whether BeamFlex+ technology is actually enable on the R770. Are there specific logs, CLI commands, or indicators in the controller interface that clearly show it's active?

Also, is there a way to objectively compare performance with BeamFlex+ enable versus disable? Ideally, i'd like to demonstrate whether this feature is making a tangible difference in my environment.

Thanks in advance for your help!

0 REPLIES 0