Could not assign ip address

Question

I am configurating IXC7150-C12-2X1G. I could not assign IP address for switchSomeone can help me please.UNIT 1: compiled on Aug 28 2019 at 13:38:53 labeled as SPR08090c      (32536860 bytes) from Primary SPR08090c.bin (UFI)        SW: Version 08.0.90cT213       Compressed Primary Boot Code size = 786944, Version:10.1.15T225 (mnz10115)       Compiled on Thu Jan 31 07:08:55 2019BYT-Ruckus-Spare(config)#ip address 10.22.3.44 255.255.255.0Invalid input -> address 10.22.3.44 255.255.255.0Type ? for a list

unknown · Answer

This all started one day when none of the endpoints attached to this switch would respond.  I observed that I could see these devices if I was connected to this switch directly but not if I was connected to an upstream switch.  Since I had exhausted all of my troubleshooting options I chose to factory reset the switch (Not with the reset button because that doesn't work at all).

This is where I'm left.

I can access my switch using the IP address handed out by DHCP but as far as getting the correct IP, subnet, and gateway  assigned im completely stumped

unknown · Answer

I'm having this very same issue and i cant for the life of me figure out why It's happening.  I have 1 out of 40 switches that's set up this way for reasons I can't understand.

I tried the following commands to no avail

- interface management 1 - ip address 10.22.3.44 255.255.255.0

I receive the following

Error: ip subnet overlap with another interface!

My working switches have an IP config that looks like this

The switch that's giving me trouble looks like this

unknown · Answer

Thank you very much.