nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

Another - not enough electricity power’ question

Richard_NZ

I have a R710 and a R650 connected to a TP-Link PoE switch SG1016PE.

The Unleashed gui tells me that ‘not enough electricity power’. It was all good before a power outage and now I get that plus the wireless speed in the house had dropped dramatically. I have read I have to switch from auto to 802.3at but I have no clue how and where to try that? Can anyone help with this please.

Find more posts tagged with

Accepted answers

Vásquez_Fer

Hello Richard_NZ ,

You could try manually setting the PoE for the access points to the maximum power that the switch can provide to ensure compatibility.

Video Link : https://www.youtube.com/watch?v=hnpSEut96iw

check the Below link :

AP Power Warnings

Link : https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-E471A9AF-2F43-4DA4-9A12-8A9BD202B543.html.

Power Limitations by PoE Mode and AP Model

https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-12E6EFCF-E117-47FA-9D07-FE2ED9D39307.html

All comments

Vásquez_Fer

Hello Richard_NZ ,

You could try manually setting the PoE for the access points to the maximum power that the switch can provide to ensure compatibility.

Video Link : https://www.youtube.com/watch?v=hnpSEut96iw

check the Below link :

AP Power Warnings

Link : https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-E471A9AF-2F43-4DA4-9A12-8A9BD202B543.html.

Power Limitations by PoE Mode and AP Model

https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-12E6EFCF-E117-47FA-9D07-FE2ED9D39307.html

Richard_NZ

I have read I have to switch from auto to 802.3at but I have no clue how and where to try that?

Ok - I found a way to do that by following the above advice. Thank you. Now the orange warning triangles have gone. I still have issues and I'll post these in another topic.

JacksonCampbell

In my experience, Unleashed has always misidentified the PoE when connected to a PoE+ source. Network equipment should not have an issue detecting that it is connected to sufficient PoE power, especially if negotiating PoE+. If it can't detect the available wattage from a PoE source, it should assume full power until it senses a power issue. When will a fix be released to address this problem with PoE+ APs?