Lennar - icx 7150 c12p config

wpthomson

Hello,

 

I am in a lennar home.  shortly after moving in we lost power and the switch lost its configuration.  someone remote in and reconfigured and said it wont happen again.  Lost power again another time and same thing happened.  Ruckus support sent a whole new switch.  We have since had the same issue with this one.  The switch appears to lose all configuration and cannot boot from a previously saved configuration.

I am able to get in via IP address with Ethernet but not sure where to go from there.  can someone walk me through how to configure this?  it does still power APs but cannot configure network.

when attempting to get into the AP via the app i get an error that says "unable to fetch default configuration from the AP"

I have solid green PWR light and Green Blinking on CTL

APs are R510 and have been reset several time as as the switch.

Chandini

Hi Wpthomson

Thank you for reaching us 

The steps provided in  the below link will help you gain console access to switch CLI 

• https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-7150-12CP-Ruckus-Switch/m-p/46759

Once you are able to access switch on console check the version on switch side if it is booting from SPS or SPR code. 

Please feel free to share output of "show version" and "show flash" from switch CLI on this post

From "show version" you would able to see if the switch is running on SPS or SPR code and booting from which flash i.e. primary flash or secondary flash.

From "show flash" you would be able to see which flash has "SPS" image and which flash has "SPR" image.

Thanks