Deployment of new wifi on all Ruckus access points

Question

Hello,

I have a local wifi network consisting of 6 Ruckus access points, 4 R320s and 2 R310s with firmware Version 200.7.10.202.121. I have only one VLAN on my network. When I create a new wifi, it remains visible on the master terminal but not on all access points. I restarted the access points but that doesn't change anything. Do you have any idea about this problem? is this a sync issue between access points? how to correct it?

syamantakomer · Accepted Answer

Hello @mohammed,

Could you check below details and provide additional information?

* Make sure that other APs (other than master) are connected and online in the master.
* Check if you are using AP groups. If yes, you must configure WLAN to broadcast on specific/all groups (if APs are part of different groups). Refer the page 193 in Unleashed 200.7 user guide.
* Login into member AP CLI using a terminal application like putty, etc. Run "get wlanlist" "get director" commands and share the output.

mohammed · Accepted Answer

Hello @syamantakomer

thank you for the respons, It was the perfect answer to my problem, the broadcasting group was not the same for all My APs.

test : one AP transfered to the main broadcast group and after a reload all works fine.

thank you very much