Ruckus will not connect to my internet

Question

Hello,

I am a Lennar homeowner.  We have not been able to use our internet for days and our cell service isn't great where I live, so without our wi-fi it has been very difficult to use any of our wi-fi connected devices.  I have already trouble shot with resetting and rebooting and that didn't do anything.  I then had an IT person look at our system and he said our Ruckus isn't working and to contact them.  He said the internet at the router is working, it's plugged into the switch Ethernet ports but the switch isn't working.  We really need this resolved quickly, because as I said we haven't been able to use our computers/TV/phones for days now.  I have already created a case #,  but the emails keep telling me to go here? Please advise.

Thanks-Stacy

imran.sanadi@commscope.com · Answer

Hi @5476Stacy

Greetings!!!

Thank you for the response and the information you shared.

As you are seeing the ‘ruckus>’ prompt is of Unleashed and NOT of the ICX-7150-C12P Switch. You should see ICX7150-C12 Router> OR ICX7150-C12 Switch> prompt.

You should see the Switch Dashboard as shown in the below screenshot to confirm it’s a Switch IP Address.

Please check the other IP Addresses from the IP scan results, by the name of Ruckus Wireless or Brocade Communications to confirm the IP address of the Switch and access the CLI.

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

5476Stacy · Answer

Hello,

I followed your instructions, but the commands don't seem to be working.  Please view screen shot below-

Please advise-

Stacy

imran.sanadi@commscope.com · Answer

Hi @5476Stacy

Greetings!!!

Thank you for the response and the information you shared.

As per the light status of the RUCKUS ICX-7150-C12P Switch and the Access Points, they are in a normal state. We may need to check some Switch configurations to troubleshoot this issue.

Please follow the below steps and help us with the queries:

1. To check this issue, we must identify the ‘current’ IP address assigned by your local router to the switch ICX-7150-C12P

I will leave you a guide on how to perform an IP scanner on your local network to identify the switch IP address very easily.

How to find my Ruckus “Devices IP address” using free applications:

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-find-my-Ruckus-Devices-IP-address-using-free-applications/td-p/47027

2. Once we identify the IP address of the switch proceed to access remotely to the device “Command Line”

How to remotely access to 'ICX 7150-C12P' or 'access points' "Network devices":

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-remotely-access-to-ICX-7150-12P-or-access-points-quot/td-p/47388

If you can access the Command line should look like this:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command

enable

show version

show flash

show inline power 
show interface brief

Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.