Hey Folks,
is there special trick configuring Ethernet Ports in SmartZone v-SZe Controller?When i select a Port and click "Configure" we always get this error:
What I am missing?
Regards
Peter
Hi Peter_riederer_
Thank you for reaching us.
Thanks
Hello Chandini,
the Switch is just fresh out of the box. There is no configuration on any port so far.IP via DHCP, SmartZone Management enabled and Firmware-Update to the latest Version.
i thought i will be able to configure the vlans to the port bei clicking "Configure"
Ack and Thanks for reverting.
Correct you should be able to view port settings when you click "Configure" options.
Link reference:
Could you help me with below information:
we are using v-SZe with:Controller Version 6.1.1.0.959Control Plane Software Version 6.1.1.0.446AP Firmware Version 6.1.1.0.1274Switch Firmware: RDR10010a_cd3
Cli is working without any issues from v-SZe
Please log a SmartZone case with us. More troubleshooting would be needed to understand the cause from SmartZone side.
Please use the below link to reach out to us for logging a case:
https://support.ruckuswireless.com/contact-us
Hi Peter,
This issue has fixed on vSZ versions 6.1.2.0.x and 7.0.0.
