mac-vlan-permit ports

bob_colon

Hello,  

I have a Ruckus ICX7150 switch that I'm having issues with.   I'm trying to get 802.1x RADIUS authentication enabled on some ports,.   When trying to remove the port from all vlans I get this message:

SSH@TPAJDSW01-01-IDF1C(config-if-e1000-2/1/30)#vlan-config remove all
Error - Port(s)ethe 2/1/30 are 'mac-vlan-permit' ports
Port(s) ethe 2/1/30 can not be removed from VLANs 1 100

When I look at the configs of vlan 1 or vlan 100,  I don't see the ports mentioned.

There is nothing on the config of the  port itself:

SSH@TPAJDSW01-01-IDF1C(config)#sh ru int e 2/1/30
interface ethernet 2/1/30
inline power power-by-class 3
!

I can't find anything in the configs pertaining to mac-vlan-permit.   in the configs.   Is there someone who can help  The switch is running SPR08090g firmware.

Thank you!

Chandini

Hi Bob_colon

Thank you for reaching us 

From the details shared i suppose you mensioned that you see no related commands in the configuration to mac-vlan-permit. 

For example i have attached a picture below.

From the details shared looks like you have checked the configuration in vlan and interface and dont see any mac-vlan related commands in the configuration is what i undretsnad. Correct me if i am wrong. 

I did try looking into security guide for 8030 and 8090 and looks like the mac-vlan commands are only available until code 8030. 

Could you please help me with below details. 

• Have you tried upgrading the switch recently ?
• Please help with output of below commands 
  • Show flash
  • Show version 
• Also could you please check and let me know if you are able to execute below commands in 8090 version
  • show table-mac-vlan
  • show table-mac-vlan e 2/1/30
• Are you seeing issue with only port 2/1/30 ?

I hope this helps

Thanks